After screen change when i put it together i get flashing red light and 0% battery …it doesnt turn on!! Battery was fine before this …it has been plugged in a long time what can i do?
Usually it’s best to disconnect everything and try again. Hopefully the battery wasn’t damaged but that seems unlikely. It could just be that something isn’t connected properly.
What kind of tape is good for replacing the tape that secures the ribbon cables to the motherboard? Every tutorial says to save the tape for later use, but after removing it did not reapply very well. I can only find fouble sided tape for cell phones but the original tape is not double sided.
If you need a single sided non-conductive tape then Kapton is probably your best bet.
Your email address will not be published. Required fields are marked *